ADBL Vampire Liquid

DEIRONIZER

Removes brake dust, volatile rust and other metallic contaminants. Semi-liquid consistency makes it easier to spray, prevents any run-offs and enables longer action. Neutral pH means it is safe for any type of external car surface. Perfect for ongoing rim and paintwork cleaning.

ADBL VAMPIRE LIQUID

ADBL Vampire Liquid is a very effective iron fallout remover for removing brake dust and other iron impurities from the entire body of a car. Thanks to its liquid consistency, it is perfectly sprayable on any surface, does not run off and does not dry out quickly, allowing for more extended work.

WHY SHOULD I USE IRON REMOVER ON MY CAR?

There are two types of dirt deposit particularly intensively on the rims and lower body parts: tar and brake dust. To remove tar, we use a dedicated tar remover.

Where do the iron-based contaminants on the rims and body of the car come from? Their main source is dust resulting from the abrasion of brake pads, which easily binds to other surfaces. To remove iron impurities, you need to use special iron fallout remover products, e.g. ADBL Vampire Liquid. Their composition has been specially composed to dissolve the residues of any iron-based impurities efficiently.

It is worth noting here that attempts to remove iron-based particulars mechanically may also turn out to be effective, but with a high probability will lead to damaging the paint. Overall the use of fallout removers is therefore not only to improve the work but also to guarantee full safety for the cleaned elements.

Is ADBL Vampire Liquid Iron Fallout Remover Safe For Paint And Wheels?

The neutral pH makes it safe for all surfaces outside the car and can be used for the daily care of all types of rims and paint. It copes well with the current dirt that everyone meets on the road.

The use of fallout removers is simple and limited to following a few basic rules. First, clean the surface of loose dirt. This will facilitate the absorption of the fallout remover active agents by the iron deposit. The product is applied to a cool element in the next stage and left for a few or several minutes. The time depends on the drying rate of a given product and the speed of penetration. In this matter, it is worth using the manufacturer’s recommendations contained on the packaging label.

You can apply the iron remover with a spray bottle, and in the case of particularly stubborn stains, they can be worked out by hand using a microfiber cloth, wash mitt or soft bush. In the end, rinse the cleaned element with a copious stream of water. It sometimes happens that a single use of a fallout remover does not remove all metallic impurities fully. In such a situation, you simply have to repeat the entire process from the beginning until you get a satisfactory result.